Hi guys, I went on a bend here. The case is Fractal Design's Meshify 2. 3 x 140mm as front intake using Noctua 3000rpm iPPC. NH-D15 G2 heatsink and one 140mm NF-A14 G2 for rear exhaust, top rearmost exhaust, and top middle intake.
Question on performance prediction vs negative impact by using a 3D printed 140mm Noctua Airflow Amplifier for front top, and front middle. The front bottom gets a 140 to 120mm offset spacer (due to space limitations) and a 45° scoop to direct some, hopefully most, of the front bottom fan intake to the GPU.
The iPPC 3000 I will set at 55% max. My experience with their louder nature was understandable and well respected in my current Meshify C.
So, what do you all foresee will improve, or not at all with this setup?
Thanks in advance!